Mechanical Contractor in Carrollton: Commercial HVAC, Refrigeration & Mechanical Services

If you run a business in Carrollton, your building probably has more moving parts than you think. Rooftop units, walk-in coolers, kitchen hoods, and maybe a boiler in the back. A mechanical contractor works on all of it, and that’s the whole point of this page. Xtreme Air Services – Carrollton is a fully licensed and insured HVAC, plumbing, and electrical contractor (HVAC License #TACLA29023C) serving Carrollton since 2009. We cover the full life of your equipment, from install to repair to upgrade.

Here’s why that matters. A lot of Carrollton’s office parks and flex buildings went up between the 1980s and the 2000s. Much of that equipment is reaching the end of its run at about the same time. When your RTUs, ductwork, and refrigeration start aging together, one team that knows the whole building saves you a lot of phone calls and finger-pointing.

Below, you’ll find each service in plain English, so you can figure out which one fits your problem. Home comfort jobs go to our HVAC contractor pages. This page is about your business.

Not sure where to start? Call us and talk it through with a real person.

Commercial HVAC Installation Covers New Systems and Full Replacements

Say your building’s AC unit is 20 years old and the repair bills keep stacking up. Or you just leased a space that needs more cooling than it has. That’s when commercial HVAC installation makes sense.

Commercial HVAC installation covers new rooftop units, split systems, and full system replacements. Most single-story office parks and retail centers along Trinity Mills Road and Josey Lane run on packaged units. A packaged unit is an all-in-one box that sits on the roof and handles heating and cooling in one cabinet. Swapping one out takes a crane, a roof curb check, and careful hookup to your existing ducts and power.

Sizing is the step people rush. A unit that’s too big cycles on and off and never pulls the humidity out. If it’s too small, it runs nonstop through a North Texas August. We look at your space, your load, and how the building gets used before we pick equipment.

One thing to know: commercial HVAC installation is equipment-level work inside a system you already have. If you’re building a system from scratch, that’s mechanical design-build, and it’s covered further down.

See what commercial HVAC installation looks like from start to finish.

Commercial HVAC Repair and Maintenance Keeps Equipment Running

Is something broken right now, or do you just want a checkup? Commercial HVAC repair and maintenance handles both, one call at a time.

On the repair side, we find out why a unit quit and fix it. On the maintenance side, we make a single visit to clean, test, and tune your equipment when you ask for it. There’s no contract. You call when you need us. Here are some signs it’s time to call:

• Warm air blowing in one zone while the rest of the building is fine
• A unit that short-cycles, clicking on and off every few minutes
• Water pooling near an indoor unit or dripping through a ceiling tile
• Grinding or squealing coming from the roof
• Energy bills that jump for no clear reason

This is different from commercial preventive maintenance. Preventive maintenance is a standing contract with visits on a set calendar. Commercial HVAC repair and maintenance is the as-needed version, for when something’s wrong or you want a one-time look.

North Texas summers are hard on equipment, and breakdowns tend to land on the hottest days. Get the full rundown on commercial HVAC repair and maintenance.

Rooftop Unit (RTU) Service Matches Carrollton’s Low-Rise Buildings

Walk any business park in Carrollton and look up. You’ll see rows of boxy units on the roofs. Most commercial buildings here are low-rise, so they use packaged rooftop units instead of a big central plant in a basement.

Rooftop unit (RTU) service is built around that setup. Each RTU usually serves one zone. So when your back office is hot and the front is fine, the problem is often one unit, not the whole system. That’s a common mix-up, and it’s good news. You probably don’t need everything replaced.

On a typical rooftop unit (RTU) service visit, we check the compressor, the condenser coil, the blower motor, the belts, and the economizer. That’s the damper that pulls in outside air when it’s cool enough to save energy. We change filters, clear drain lines, and look over electrical parts that take a beating from roof heat. Summer sun on a flat roof gets brutal.

Then we tell you plainly what we found and what can wait.

Learn more about rooftop unit (RTU) service for your building.

Commercial Refrigeration Supports Restaurants and Retail Coolers

Commercial refrigeration is the cold side of your business. It covers the compressors, condensers, evaporators, and refrigerant lines that keep food and product at a safe temperature. Reach-in units, display cases, prep coolers, and the systems behind them all fall under it.

For a restaurant or grocery store, refrigeration isn’t about comfort. It’s about inventory. A system that drifts a few degrees overnight can cost you a full delivery and a stressful morning. So we focus on finding the real cause, not just topping off refrigerant and leaving.

Carrollton has a lot of strip centers with restaurants and markets packed side by side. Those rooftops and back walls get hot, and condensers that can’t shed heat work harder every day.

Think of commercial refrigeration as the umbrella service. If your problem is a walk-in cooler or a walk-in freezer, each one has its own section below, because they fail in their own ways.

Find out how we handle commercial refrigeration calls.

Got a refrigeration or rooftop problem today? Call Xtreme Air Services and talk to a real person about getting it fixed.

Commercial Kitchen Ventilation Clears Heat and Grease Safely

A hood is only one piece of a working kitchen. Commercial kitchen ventilation is the whole system that pulls heat, smoke, and grease off your cooking line and brings fresh air back in.

That system has three main parts. The hood captures what comes off your fryers and grills. Exhaust fans push it out through the roof. And makeup air replaces the air you’re pulling out. Skip that last part and your kitchen goes negative. Doors get hard to open, pilot lights flicker, and your dining room pulls in hot air from outside.

Exhaust hood installation is the service for putting in the hood itself. Commercial kitchen ventilation looks at how everything works together, including airflow balance, fan performance, and grease buildup in the ductwork.

If your line cooks sweat through every shift or smoke hangs in the air, the hood may be fine. The balance is often what’s off. Fire and health inspectors care about this too, so it pays to get it right.

Read more about commercial kitchen ventilation for restaurants.

Ready when you are – get in touch today.

(469) 269-6099

Call Today, Get Service Today. Xtreme Air Services — Carrollton is ready to help.

Walk-In Cooler Repair Fixes Compressor and Temperature Problems

Your walk-in cooler and walk-in freezer sit side by side, but they don’t break the same way. Walk-in cooler repair deals with a box that runs around 35 to 40 degrees. At that range, the trouble is usually the compressor or the condenser.

Here’s the common story. The condenser coil gets clogged with dust and grease. It can’t get rid of heat, so the compressor works harder and longer. Eventually the cooler creeps up to 45 and won’t come back down. Door gaskets that don’t seal and fans that stop spinning cause the same slow climb.

Walk-in cooler repair starts with a real diagnosis. We check refrigerant pressure, coil condition, fan motors, and the door seal before replacing anything. That’s how you avoid swapping a part you didn’t need.

If you notice your cooler warming up, move high-risk items to another unit and keep the door shut. Then call us. A warm cooler on a Friday afternoon is no fun, but it’s usually fixable.

Get the details on walk-in cooler repair.

Walk-In Freezer Repair Addresses Ice Buildup and Defrost Failures

You open the freezer and there’s frost all over the evaporator coil. Product near the back is going soft. Walk-in freezer repair is for exactly that.

Freezers run at zero or below, so they need a defrost cycle. A timer or control shuts off cooling for a few minutes and warms the coil to melt off ice. When that cycle fails, ice builds up until air can’t move through the coil. The box starts warming even though the compressor is running fine. These are the usual culprits:

• A bad defrost timer or defrost control board
• A burned-out defrost heater
• A frozen or clogged drain line
• Door heaters that quit, letting frost build on the frame

That’s the key difference from walk-in cooler repair. Coolers mostly struggle with compressor strain. Freezers mostly struggle with ice.

Please don’t chip ice off the coil with a knife or screwdriver. It’s easy to puncture a line and turn a quick fix into a refrigerant leak.

See how walk-in freezer repair works.

Commercial Preventive Maintenance Reduces Unexpected Breakdowns

Commercial HVAC repair and maintenance waits for you to call. Commercial preventive maintenance doesn’t. It’s a standing contract where we show up on a set calendar to inspect and tune your HVAC and refrigeration equipment before something fails.

North Texas gives your equipment two tough seasons. Summer heat pushes rooftop units and refrigeration hard, and winter freezes hit heating systems and boilers. So we time visits ahead of each one. A typical commercial preventive maintenance visit covers:

• Filter changes and coil cleaning on rooftop units
• Belt, motor, and electrical checks
• Refrigerant pressure and temperature checks on coolers and freezers
• Drain line clearing and condensate checks
• A written list of anything that needs attention

In my view, this is the service most businesses put off the longest. That’s understandable. When everything’s running, a contract feels optional. But the breakdown you avoid in July is the one that could’ve closed your doors for a day.

If you’re weighing commercial preventive maintenance against pay-as-you-go repair, think about how much downtime your business can handle. Compare your options for commercial preventive maintenance.

Not sure what your Mechanical Contractor project needs? Ask us.

(469) 269-6099

Call Today, Get Service Today. Xtreme Air Services — Carrollton is ready to help.

Boiler Installation Anchors Heating for Larger Commercial Buildings

Boiler installation is new boiler setup for a building that doesn’t have one yet. That usually means new construction or a major renovation where hot water heating makes more sense than forced air.

Boilers heat water and send it through pipes to radiators, coils, or in-floor loops. They’re common in larger buildings and spaces that need steady, even heat. Boiler installation includes sizing the boiler, setting it, running supply and return piping, venting, and connecting gas, water, and controls. Then it has to be fired up and tested before you rely on it.

Already have a boiler that’s worn out? That’s boiler replacement, a separate service. Boiler installation is for first-time setups. It’s also the starting point for the whole boiler life cycle we handle:

• Boiler servicing and boiler maintenance to keep it running
• Boiler repair when something fails
• Boiler upgrades to modernize what you have
• Boiler decommissioning when it’s time for it to leave the building

Each of those has its own page. North Texas doesn’t get many hard freezes, but when one hits, a heating system you can count on matters. Start with the basics of boiler installation.

Mechanical Design-Build Services Plan Full Systems From Scratch

Are you replacing a unit, or building a system? If you’re building one, you need mechanical design-build services.

Mechanical design-build services cover planning and building a new mechanical system from the ground up. That’s heating, cooling, ventilation, piping, and controls, all laid out together for new construction or a major renovation. One team handles the design and the build, so the plan and the install match.

That’s the big difference from commercial HVAC installation. Commercial HVAC installation replaces or adds equipment inside a system you already have. Mechanical design-build services start with an empty floor plan or a gutted building and figure out what the whole system should be.

If you ask me, early planning is where most of the value lives. Duct routes, equipment spots, and roof loads are easy to change on paper and hard to change after the walls go up. Bringing the mechanical team in early saves headaches with your general contractor and inspectors later.

This is also where one team for HVAC, plumbing, electrical, and refrigeration pays off. Fewer handoffs mean fewer gaps. Explore mechanical design-build services for your project.

Planning a project or dealing with a breakdown today? Call Xtreme Air Services and talk to a real person who knows Carrollton buildings.